High performance saw blade. For straight and very clean cuts. Ideally suited for HPL and acrylic decors.
This high-performance saw blade is ideally suited for straight and clean cuts in thicker panel materials between 5 mm and 85 mm. It is therefore suitable for all our surface coatings. Especially HPL and acrylic surfaces can be processed very well. It fits in jigsaws with T-shaft mount.
As with all saw blades, the same applies here: A new, sharpened saw blade naturally cuts best. Therefore, make sure that you always use a sharp saw blade when processing your Queenply. Basically, the saw blade is of very high quality, so that you can assume a long service life.
Especially with our coated panel materials, the ambient temperature during processing is important - it should not be too cold or too hot around you.
The high-performance saw blade is suitable for Queenply plywood with the following coatings: HPL, acrylic, plastic, PVC as well as glass fiber reinforced plastics. Of course, you can also process our untreated panels with it. The saw blade is designed for all jigsaws with T-shaft.
- Working length: 108 mm
- Material thickness (min./max.): 5 – 85 mm
- Tooth pitch: 3.3 mm
- Quantity per package: 5 pieces
- Total length: 132 mm
- Finish: sharpened and ground
This saw blade is available in our store in a set of 5 pieces.
Before you start processing our lightweight panels, please ensure that you take adequate safety precautions, such as wearing protective goggles and a face mask. It is also advisable to use an exhaust system for the chips, as the lower weight of our queen results in increased dust generation during processing.
As a general rule, it is advisable not to start sawing until the saw has reached the correct speed (for circular saws: number of revolutions). You can also get more information about the product on the manufacturer's website.