Honeycomb six-tooth milling cutter, spiral fluted HCS
€49.29
This product or format is actually not available. We're getting supplies right now.
Product information "Honeycomb six-tooth milling cutter, spiral fluted HCS"
For maximum cutting volume. Spiral fluted. With counter-rotating chip breakers. In two lengths.
Milling is not easy. And to ensure that you succeed in the best possible way, we have provided a selection of milling cutters with which our professionals have already had good experience. Because, as we all know, a good result starts with the choice of tool.
This six-tooth milling cutter with counter-rotating chip breakers ensures good guidance. The steep helix exerts only gentle traction on your workpiece. Delamination of the material layers is prevented. The milling cutter has very good plunging behaviour thanks to a central tooth. The pitch of the spiral flute is 10 degrees.
You can use it to mill our MDF and multiplex panels. And it is very suitable for HPL.
You can obtain the router bit from us in 60 mm or 75 mm overall length. When selecting, please note that different diameters apply for the cutting edge and shaft:
Length 60 mm = Ø cutting edge: 6 mm / Ø shank: 6 mm
Length 75 mm = Ø cutting edge: 8 mm / Ø shaft: 8 mm
You can order your right version here on this product page by using the selection buttons. Further technical information can be found in the ‘Technical details’.
We have summarised the most important technical information about the six-tooth cutter for you here:
- Overall length: either 60 mm or 75 mm
- Cutting edge diameter: 6 mm (for 60 mm total length) or 8 mm (for 75 mm total length)
- Shank diameter: 6 mm (for 60 mm total length) or 8 mm (for 75 mm total length)
- Length of cutting edge: 22 mm (for 60 mm total length) or 32 mm (for 75 mm total length)
- Design of the cutting edge: Cylinder
- Number of cutting edges: 6
- Pitch of the spiral flute: 10 degrees
| Ø D1 | Ø D2 | L2 | L1 | |
| M6 × 22 | 6 mm | 6 mm | 22 mm | 60 mm |
| M8 × 32 | 8 mm | 8 mm | 32 mm | 75 mm |
You can also watch the processing video on our YouTube channel on this subject. You might find one or two tips there.
Before you start further processing and finishing work on our lightweight panels, please make sure that you have adequate protective measures in place, such as wearing safety goggles and, if necessary, a face mask. For drilling or sawing work, it is advisable to additionally wear hearing protection.
Especially with our coated panel materials, the ambient temperature is important during processing. Therefore, make sure that the room temperature is comfortable when you start.
For more information on the screws, please visit the manufacturer's website, as well.